SpeedDrive for E3D V6 + BMG (Pancake compatible)

thingiverse

Sources: https://www.thingiverse.com/thing:3816051 SpeedDrive, https://www.thingiverse.com/thing:3291101 HeroMe for E3D V6 This remixed version of sashalex007's SpeedDrive is specifically designed to work seamlessly with an E3D V6 in combination with the BMG extruder. Sashalex has expressed reservations about using the V6 due to its less rigid mounting solution compared to a stock or microswiss, but I had my V6 already installed and was not willing to invest in a theoretically inferior extruder. I remixed the SpeedDrive mount to ensure perfect alignment between the BMG and V6, and also remixed the HeroMe mount for the V6 (originally designed by mediaman) to eliminate the cable guide, which would otherwise be obstructive. This setup can accommodate a pancake stepper motor with a maximum diameter of 23mm, as tested on an Ender 3 with approximately 0.5mm clearance. I extend my gratitude to kasparsozols for testing and identifying a small error that could compromise the stability of the part, which I promptly corrected. He also remixed my version to incorporate a cable chain attachment: https://www.thingiverse.com/thing:4007955 The mockups showcased are his creation, and I appreciate his generosity in allowing me to utilize them. I have only remixed the initial two parts (speedDrive_mount_bmg_e3d_v6_v1_1.stl and HeroMe SpeedDrive.stl), but included all necessary components for your convenience. Since this is essentially a one-off build for me, the pieces are remixes of the currently available base versions (as of Nov 24, 2019) and will not be updated if the original parts undergo revisions. At least, not by me. If the original designers of these pieces wish to have their non-remixed versions removed, please reach out to me. So far, this setup is working flawlessly. I opted for Lightweight Fan Ducts for my dual 5015s; you should visit the original part and select your fan ducts accordingly, striving to maintain a lightweight configuration.