Spectrum DX-9 FPV Monitor holder for Boscam RX-LCD5802 Diversity Monitor

thingiverse

Inspired by the creator of the post on Thingiverse, http://www.thingiverse.com/thing:384223, I took the concept and reworked it to fit the DX 9 spectrum transmitter and adapted it accordingly. As an FPV monitor, the Boscam RX-LCD5802 Diversity Monitor is utilized. It must be printed with support material, with a fill density of 35% achieved during printing. To prevent the holder from slipping off the transmitter antenna's dome, the antenna recording dom should be filled with foam. Alternatively, the antenna mounting points at the back of the antenna can be transferred to the receiving dome, allowing the holder to be screwed directly onto the transmitter. The monitor itself is secured and fixed by a screw-nut combination. In addition to the holder, these parts need to be printed as well, and M5 square nuts should be added to the screw-nuts. The screw retainer for keeping the receiver in place comes equipped with 2 countersunk screws, M5x10 in length. On the diversity receiver's receiving dom, the screw housing is slightly loosened before inserting the recording, then tightened again carefully to ensure that the countersunk screws are fixed and do not rotate when the monitor is screwed on.