Spear of Destiny - As seen in the movies

thingiverse

This is the Spear of Destiny, still in development mode at this point. It stands 16 inches tall, getting as close to the images attached as possible. Designed specifically for mounting on a 1-inch Staff Important Note: I've created the design, but haven't printed it yet. If you have access to a large printer, all you'll need is to print: - Spear Tip - Spear Mount - Two Wraps - Center Piece If space is limited, you may want to break down the spear into sections. Run it through your modeler before printing for best results. I might come back and mesh it later to give it a textured rugged look. Enjoy! I'll post pictures as soon as it's printed. 7/13/2017 - Updated Spear with increased center opening. It got cut into 4 pieces to print. 7/24/2017 - Center Piece Spire Update: There are two versions, one with support and one without.