SPD Bicycle Cleat Adjust Tool

prusaprinters

<p>Design is intended to allow more repeatable accurate adjustments of SPD (MTB) shoe cleats.</p><p>Not necessary but embossed text looks better if you do a colour change at 0.8mm Z height and a change back at about 1.4mm {Note the slicer photo attached is a MMU type colour change - you can do colour change without the MMU) .</p><p>Appreciate feedback / suggestions to improve.</p><p>Length of the tool was largely determined by my print plate and my size 43 shoe :)</p><p>There are plenty of You_tubes on cleat adjustment to give options on best setup.</p><p>Need to rotate print 45° for a 200 x 200 print plate. If you do you may wish to change the infill angle as well to 45°.</p><p>Print is designed to have the Text side down on the print plate.</p><p>I used PLA (eSun ) with 0.2mm layers. No supports or rafts are required</p>