Sparkmaker Resin Tower test v4

thingiverse

NOTE: THE CODE ONLY WORKS WITH SPARKMAKER!!! This tower test is a gauge on how your resin will print with Sparkmaker's printer. The poles on the model are to gauge how well your Sparkmaker and the resin will print at different cure times. If you notice that the 1mm pole doesn't print well in one of the pre-set cure sections, it's not recommended to use that cure time for that affected section. This is a resin cure time test tower for SParkmaker DLP Printer. It prints the tower with decrements of 2 seconds per 10mm height. To print, simply place the print.wow file in the root of your SD card and start printing. How to select your cure time based on the test tower: - Perform a visual inspection on the print and check which section of cure time gives you the best clean print result. - Once you've found the section that provides the best clean print result, use the time label on that section for your "layer exposure" print setting. Slice info: Uv light strength: 255 Layer height: 0.1 Z motion: 30 up/80 down Z lift: 5mm Item dimension: L: 20mm B: 9mm H: 51mm Circle dimension: 1mm at 25 degrees (added 19th Feb 2018) 1mm 2mm 3mm