Spark/Mavic "GO" universal tablet holder

thingiverse

I Designed a New Tablet Holder That's More Than Just Portable The previous tablet holder I designed had its advantages and disadvantages, but it was too hard to assemble and not very portable. Now, I've come up with a new design that's less portable, but ready to use in just two gestures. Check out my other designed holder: https://www.thingiverse.com/thing:2899878 To make this tablet holder work, you'll need the universal tablet grip (2 pieces), which is the only support required. When printing, insert the two nuts into the clamps around layer 30, so they won't get lost later on. I printed the clamps separately from the rest of the parts and placed them apart on the printer bed to make it easier. The universal holder should be attached to the top joint with a small amount of glue and a 3mm screw. Here's what you'll need: two 5mm screws, two 5mm nuts, and one 3mm screw. On the side of the universal brackets, place a rubber ring that will help tighten it in place.