Spare filter box for Respirator Mask "Brasil"

prusaprinters

<p>peter m’s face mask is so useable that I needed a box for carrying spare filters around in. There’s also a smaller compartment for a spare insert, adjusting clips, strap etc. The case and cap latch together, so it should be safe in a bag without spilling everything. Also included is a stencil for cutting out filters (embossed as such since some of my friends aren’t that smart, and you always forget what small unmarked pieces of plastic are actually for after a few months;-&gt; For people with better memories, the STL file isn’t embossed.<br/> The insert compartment is a tight fit so the actual insert stops any small clips falling out.</p> <p>This works fine in PLA, but will probably last longer in PETG.</p> <p>The whole lot takes about 6 &amp; 3/4 hours to print using a 0.15mm layer; a single stencil is 20mins, the case 4 &amp; 1/4 hours and the cap 2 hours if you print separately.</p> <p>Layer height: 0.15<br/> Infil: 15%<br/> Shells: V 2, T 7, B 5<br/> (I.e. Prusa Slicer defaults)</p> <p>For speed over beauty I’d suggest a larger layer height.</p> <p>Respirator Mask "Brasil”:<br/> <a href="https://www.prusaprinters.org/prints/29745-respirator-mask-brasil-xs-s-m-l-xl">https://www.prusaprinters.org/prints/29745-respirator-mask-brasil-xs-s-m-l-xl</a></p>