SpaceX Starship and Superheavy

thingiverse

This is a remix of the moveable flap SN8, I changed the engines to match the Predicted engine layout for starship, along with added heatshield sections. Printed with a Ender 3 !!!8/13/2021: added the grid fins modeled after the official BN4, and 3 RVAC engine layout. working on the aft section currently. NOTE anything marked with "NEW" has not been printed and thus may need to be tweaked !!!8/18/2021: fixed the problems with "SN20 AFT NEW" Rvacs causing holes in the walls. i have fixed and updated the file and re-named it to "SN20 AFT NEW FIXED" Stands at about 2ft You will need superglue Flaps connect with 20 gauge wire Ship connectors can print in any color and any layer Hight !!You may need to rotate the models to print them!! Superheavy 1-3: print with NO supports, printed in grey with 0.3 layer Hight All heatshields: print with NO supports, printed in black with 0.2 layer Hight SN20 Fwd, and Aft: NEED supports, printed in grey with 0.2 layer Hight SN20 flaps: Print with NO supports, printed in grey with 0.1 layer Hight NOTE- if the wire doesn't fit try a different layer Hight or even a smaller wire, you also could heat up the wire a bit to melt the plastics