Spacer for 20x20 Flight Controller and 4in1 ESC (Piko BLX, Mini Lux F4)

thingiverse

Consider supporting our Patreon page to unlock more innovative designs and help us push the boundaries of what's possible. Visit https://www.patreon.com/airbladeuav today. Most, if not all, of the 4in1 6A and 10A ESCs on the market rely on M3 holes and hardware, but unfortunately, the standard hex standoffs are too large and often obstruct SMDs on the board. This spacer is designed to eliminate the need for M3 standoffs altogether. Its compact height of 4mm allows for a thin wall of just 0.8mm, making it an ideal solution that also leaves sufficient space for wires to run between the ESC and FC. Recommended Configuration: To secure the setup, use a nylon M3x16 screw that passes through the bottom of the frame, then the spacer, ESC, another spacer, FC, and finally top it off with a nut or a short M3 standoff. The total height of this stack should be between 10mm to 12mm. Print Settings: Printer: MakerFarm I3V Rafts: No Supports: No Resolution: 0.2 Infill: 20% Notes: Print with TPU.