Spacer and Arm´s Peon 230 / Abstandshalter und Arme Peon 230

thingiverse

Hello I have designed a spacer 40mm high. For all spacers, I used M3 countersunk head screws. Front: - 40 mm without bracket - 40mm with direct holder for the camera - 40mm in two different distances for the holder of the camera Middle: - 40mm without holder - 40mm bracket for an XT60 connector (https://www.ebay.com/itm/5er-Pack-XT-60-Einbaustecker-von-AMASS-fur-Gehausemontage-inkl-Schrauben/223164722040?hash=item33f5a76b78:g:IGUAAOSwPNNavP3H) - 40mm with mount for GPS. I used a 4mm thick carbon rod secured by 2 M3 grub screws (https://www.ebay.com/itm/GPS-Antenne-Halterung-Holder-Stand-Stander-Zubehor-fur-RC-Drohne/283223568617?hash=item41f170b0e9:m:mg-nVby7ScJoR4mQGR0dYrw) Rear: - 40mm mount for the FPV antenna of Team BlackSheep 5.8GHz TBS Unify Pro HV - RACE. In addition, there are guides for the antennas. I took two 3mm thick tubes. These are also held in each case by a 3mm thick grub screw (https://www.ebay.com/itm/Receiver-Antenna-Fixing-Seat-Mount-Holder-Pedestal-for-Multi-axle-FPV-Drone/283293755489?hash=item41f59fa861:m:m8KGCNvBZvRYj2R0TOsZSGw) Furthermore, I have slightly reworked the arms so that you can place the engines in different positions. In addition, there are feet that are attached with M3 countersunk screws.