Space zombies Dragon flower

thingiverse

Print entirely without support. Detach and insert a screwdriver in the hollow under the piece. Turn gently to 90° clockwise. Deploy the rotative turret. Important recommendations for extreme print: The base is 100x100mm, but you can resize it by 70% if necessary. Check your slicer to ensure that the two parts stay separate from each other when printing in FDM mode. For optimal results, push the edges of the "leaves" to rotate freely and transmit momentum efficiently to the main axis. The leaves are more resilient than the flower due to their profiled design. When scaling down the model, FDM machines may require additional supports behind the front teeth to secure them. Some FDM machines experience gaussing effects due to inadequate cooling, causing the tip of the leaves to point upward and potentially damaging the main axis. If you encounter this issue, add supports under the leaves after hollowing out space for them in the "tube." Remove these supports before attempting to turn anything. Never jump on top.