Sovol SV07 Plus Flat Cable Holder Remix

thingiverse

This is a remix of this file:https://www.thingiverse.com/thing:5593651This bracket holds the extruder/x axis cable in place as it goes up and down the Z Axis. I found the original to work extremely well for my Ender 3 S1 Pro, and when I got the SV07 Plus, I wanted something similar. The SV07 Plus being so new, there were not many upgrades/mods available, so I remixed the original to work with the Plus. It may work with the regular SV07, but I am not sure.The print in photos was printed on the SV07 Plus in PLA. I printed one in PETG on my Ender 3 S1 Pro, and it came out just as good.There is no need to remove any hardware from the printer, just work the bracket into place. The right-side upper arm should just 'click' into place over the gantry bracket when it is position. My support settings are not quite dialed in yet, so I had to do a little scraping for the bracket to 'click' into place, mainly around the little vertical tab on the front of the piece. Supports are required.30% Infill.