Sovol SV06 Lack enclosure Remix

prusaprinters

Made the enclosure taller to fit a concrete slab underneath the SV06 (haven't bought one yet..)Redesigned the door knobs to use with Clas ohlson's door magnets (https://www.clasohlson.com/fi/Magneettilukko-10-kpl/p/21-1690). This was my first real 3D printing project after a few initial test prints! It was a very interesting project where the parts were mostly pretty easy to print, but also taught me a lot on the subject. The prints for the door knobs and bottom corners with hinges need to be paused for a drop-in placement of the magnets / hinges respectively and then resuming the print. I used the original models from the Lack enclosure for the lower table and the spool holder. NOTE! With any enclosure system with Sovol SV06, the heatbed cable is going to be under a lot of stress everytime the bed moves all the way to the back, as the cable points straight outwards from the bed. My bed thermistor broke (got a new one from Sovol support!) and I read similar experiences from other people too. With the new bed I immediately printed a cable guide found from this reddit post: https://www.reddit.com/r/Sovol/comments/11nuphy/sv06_heat_bed_cable_touching_ikea_lack_enclosure/ (unfortunately the model is only linked on this thread as a download link, not found on Printables). This model redirects the heatbed cable to the side, and so far everything seems fine!