Sovol Sv04 Dial Indicator Mount for Bed Level/Tramming

cults3d

I have removed Version 1 and replaced it with a much-improved version 2! Print at 0.2 layer hight at 20% to 40% fill. Parts Needed: Dial Indicator. I recommend getting a digital one I use https://www.amazon.com/gp/product/B0925K3F9Z/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 Print and use the Pin like in the photos or use Nut and Bolt combo - Metal 1/4-20 (~6mm) To install place top of clip on first and push bottom in. Remember to remove after your done leveling and store your dial indicator in it box to keep it safe. I have also added a hole on the top so you may use a bolt to help keep it more secure onto your printers fan. This should not be needed at all. Now to use this on the SV04 you need to set up your printer to leveling mode. Then tell it to move to a corner to start leveling the corner. Here I recommend turning off the printer and moving everything by hand to level each corner. Now you will need to install the dial indicator over the fan and move the extruder left until the dial indicator is over the bed leveling screw. Once you have the corner where you want it, zero out your dial indicator and make all the corners read zero. You may need to do this 3 to 4 times, the more you do it the better results you will have. Good Luck and take care, if you do this wrong you can damage your printer. I will not be responsible, you been warned. Here the tinkercad link if you like to make changes https://www.tinkercad.com/things/fGOLHULoeU0-sv04dialindicator