Sovol SV01 Rear Z Frame Bracing

thingiverse

SV01 Z gantry bracing. You will need: - 2 x 12x500mm carbon fibre tube - 8 x M3x12 screws (button head or cap it's up to you) - 8 x M3 nuts - 12 x M5x16 countersunk screws - 2 x M5x12 countersunk screws - 14 x M5 T-nuts The two upper brackets print without supports. The two lower ones need some support under the very steep overhanging side. A thin strip of support (about 5mm wide is enough) at each end will do. Put a support blocker in the middle and across the lesser overhang as there is no need for it to be fully supported. A brim is probably also needed.