SOVOL SV01 Neoteck Digital Dial Indicator for bed comparateur fo

thingiverse

I was inspired by /thing:3340644 and thing:3148230 and GlassCurtain : thanks to authors ! Print the STL horizontally (filled: 30% or more) with supports. Use one M3 and one M5 screws to fix it to Sovol SV01, near the extruder stepper (see photo). I have added gcode for bedlevel procedure (originated from Federico Salis and Romeoknight, Many thanks!) and personalized it to support the SOVOL SV01. "Put the gcode (SV01bedlevel_hot.gcode file) on your SD card and follow these 10 steps: 1. Start your printer (without your Digital Dial Indicator) and select the file "SV01bedlevel_hot.gcode" from your SD card. The printer will auto home and heat up the heatbed to 60 degree celsius. 2. After bed has reached 60 degree, press the button on your Ender 3 display. The nozzle will move into the first measure point at the front left corner of the heatbed. Use a piece of paper to manually set the nozzle height, but only with the bedlevel screw on the front left! Meanwhile, install and switch on your Neoteck dial indicator. 3. Press the button again and the dial indicator probe will move near the spot you've just leveled. Now press the Zero button on the dial indicator! This front left corner is now your reference point (0.00mm). 4. Press the (printer) button again and the dial indicator will move into every other corner and stop there, waiting for you to level each corner with its corresponding bedlevel-screw, so that the dial indicator shows 0.00mm. After each point, press the (printer) button. The dial indicator will move into the center of the heatbed every now and then. Don't move any of the bedlevel screws here! This center measure is just for your information, so that you can get an idea of how much the heatbed is bent in the middle (I get values around 0.05mm using a glass/mirror). 5. After all measure points are done, the printhead will move into the front left corner again. Don't use the bedlevel screw here, it's just your reference point again, it should still be in the area of 0.00 - 0.05. Repeat the bedlevel procedure one more time, to make sure everything is fine. 6. The dial indicator will move into every other corner and stop there, waiting for you to level each corner with its corresponding bedlevel-screw, so that the dial indicator shows 0.00mm. After each point, press the (printer) button. 7. Don't use the bedlevel screw here, it's just your reference point again, it should still be in the area of 0.00 - 0.05. 8. Repeat the bedlevel procedure one more time, to make sure everything is fine. 9. Your heatbed is leveled now as perfect as possible for your setup! 10. Print your thing without any worries about leveling issues. Neoteck digital dial indicator (0-12.7mm/0.01mm/0.0005') used for this thing: https://www.amazon.com/gp/product/B07CMLYXCG