Sovol SV01 base profile covers

cults3d

This is a remix of the profile covers from an Ender 3. I adapted the size to fit my SOVOL SV01. I made them for the base rails as these tend to collect bits of plastic more than anywhere else. I strongly recommend printing the test piece first to try fitting, as each printer and settings can vary. If it's a snug fit, great. If not adjust the width only by a few percent using the scale feature and try again. CURA users remeber to uncheck the Uniform Scaling box otherwise the whole piece will scale rather than just the width. Other slicers, use similar precautions when scaling. Print in draft at .2mm layer height. Print the rest when you have a good fit. You will need: 4 of the parts suffixed 25 to make covers for the left and right sides, front 4 of the parts suffixed 10 to make covers for the left and right sides, rear 4 of the parts suffixed 17 to make covers for the front and rear, left and right 4 of the parts suffixed 20 to make covers for the centre rail, front and rear (2 on each side) They should all fit on the build plate side by side.