Sovol Extruder mount filament sensor

thingiverse

Remix from https://www.thingiverse.com/JSchulze https://www.thingiverse.com/thing:4702282 A good solid mount to the extruder with cable chain guides from: https://www.thingiverse.com/Passman3d https://www.thingiverse.com/thing:4314035 Thanks to these guys for sharing. This is the 4th try for me for this mount and it is finally good enough to share. The SV03 Gantry chain I verified is correct height for SV03 but I have not printed the SV01 to test yet. I have both printers and will do this upgrade to both. Use 3 of the original long screws from the filament sensor to mount cover and the 2 small ones to mount the sensor in the housing. Holes are sized to not require a Tap to thread. Just slowly run the screws in. 3x 4mm x10mm bolts with nuts hold it to the extruder. I made the middle hole smaller so you do not have to use a nut on it. the bolt will thread through it easily. You will also need to file down a little where the extruder gear is located. It touched on My SV03 but not on the SV01 but check for clearance on both.