Source One V3 Arm Protector and Skid

thingiverse

This design is intended to protect the arms and bottom plate of the TBS Source One V3 frame. This design is a remix. Thank you to ShaunyShaun and the original poster of this design. The unique thing about this remix is it maintains the more structural nature of motor screws going directly through the frame without a plastic "spacer" in between. Initially, when using ShaunyShaun's design, I didn't like the fact that there was plastic between the head of all 4motor screws and the frame itself. During a crash, if the skid was ripped off and the material between the screws and the frame was ripped out, the motor screws would be loose and the motor would not longer be securely attached to the frame. Additionally, this design allows the skids to be swapped out by only removing 2 of the 4 motor screws, leaving the motor securely attached to the frame during the swap. Motor screw seat was too thin and resulted in repeated breakages. Seat thickened to improve toughness.