Source Once Radio Tray w/ VTX ant., Beeper and Immortal T-Mount, no GPS

thingiverse

Make sure your software is up to date as of December 9th, 2019. Files should print properly by 6am. Sorry for any previous issues with SMA fitting. Try re-printing. Print with supports using the TPU. The mount has spots for SMA connectors on top or bottom VTX, a crossfire antennae holder, and an anti-prop snagger. Hex nut slots are in the SMA area. There is also an upper and lower radio area that doubles your rear frame space from the original source. This works with all versions so far! Two revisions are included: one without a beeper hoop and one for gluing in a piezo buzzer from eBay, which might be 9mm or 12mm in diameter - I forgot. If prints are too tight or loose, you may need to resize your print by scaling it inside your slicer by 1 or 2 percent. Sometimes more is needed! This design was created from scratch with Fusion 360. If you use this, give me a shout-out or thumbs-up! Thanks, friends! Enjoy! This is for no GPS. If you need a version with BN 180/TBS GPS, click here: https://www.thingiverse.com/thing:3451657