Sound Bar & Speaker Tilted Riser (For PC Monitor Use)

prusaprinters

TV Sound Bars are designed to be used at further distances, maybe 10 ft. However, many would like a sound bar as a PC monitor speaker. This set of risers angles your sound bar, so the speakers are pointing towards your ears, not your chest or belly.CompatibilityAny rectangular sound bar would fit; the depth of the ramp is 4 inches, so anything not much bigger than 4 inches is perfectly compatible.The bottom of the sound bar is risen by about 1 inch above the desk surface so that there is clearance for your monitor base/keyboard/mouse pad. See the picture for reference.Optional Additional MaterialsIt is recommended to have ½ inch felt pads or silicone bumpers to be installed into the holes/pits. They will both serve anti-slip and provide a cushion between the riser and your sound bar, to remove undesired vibration or noise.Here is one for reference. Not affiliated, it's just a common model.Any foam tape or acrylic tape would work just fine. Recommended Printing SettingsMore than 3 wall and shell loopsMore than 15% infill rate.Print with the sides on the plate, so no support is needed. If you print with the pits/holes down, you should enable support.