SOPORTE LAMPARITA LED USB PARA ANYCUBIC KOSSEL PULLEY (USB LED LAMP SUPPORT FOR ANYCUBIC KOSSEL PULLEY?)

thingiverse

We purchased an LED lamp that plugs directly into any USB port and provides plenty of light. I insisted on placing it on my 3D printer because the current lighting comes from the ceiling, making it hard to see how prints are progressing. This LED lamp would normally be powered by a battery used for charging mobile phones, so I decided to design a stand with an on/off switch that connects the lamp to a 5V output on the Anycubic Kossel's electronic board. For now, I'm still plugging it into the battery, but it's already in its designated spot. The stand is secured using two M4 screws, 15mm long, which were leftover from the printer's assembly. I had ordered them as replacements, but they proved to be too short for my needs - one was longer than necessary, while the other didn't fit properly. However, I've made the necessary adjustments in the design files (Freecad and STL) and am waiting to test the revised model. The lamp itself is angled to point directly at the print area. While it's a bit crude, it serves its purpose for now.