Soporte Bobina pared tubo PVC 22mm, altura 10mm /15mm y tornillo M6 (Support filament)

thingiverse

I bring you one of my creations, and I'm really proud of it - I made this little gadget myself. It's actually kind of silly, but to me, it looks amazing, and it's going to be super useful for holding up my filament rolls. It's a wall mount support for tubes with an outer diameter of 22mm. The whole thing is only about 10-15mm tall, which is nice and compact. It has my custom NT76 logo on it, too - I really wanted it to have a bit of personal touch. As for how I built this little device, well, here are the instructions: To make sure everything stays securely in place, I set my infill density to 50%. I then heated up my hotend to 232 degrees Fahrenheit and the build plate to 100 degrees Fahrenheit. I also made a special point of applying an extra layer of adhesive caulk at the three corners, which was a big help in preventing any lifting during assembly - that was pretty much done using some dimafix material, I applied lots more lacquer for those sharp points!