Sony SEL2870 kit lens hood

thingiverse

The one you want is the bipetal-reversible, takes 5 hrs to print same settings as below the other ones either have vignetting problems/too large or maybe too small (white prints) I had to remove the over-spin bits for the reversible layer since they were causing vignetting (ugh). I sanded them off and it looks better, I believe no vignetting. The locking ring area could probably be reduced in height but I'm done messing around with this thing. ------ OLD --------- A lens hood, I included square and tulip design, these are free handed. I also attached the locking mechanism itself that I also freehanded. 2hrs to print tulip with standard settings for PLA on Ender 3 Pro 0.2mm 50mm/s print speed This hood does not thread on in reverse for storage. Edit: I think this design is bad, needs to flare out more, it's short because at 24mm the sides were visible. Lock is good, nice fit Tulip Large is kind of a joke... I matched the 24mm viewing angles but I got the length wrong from the original hood eg. about 1.6" tall and this one is 3.5" lol The large tulip takes 4 hours to print, it is comically large and has vignetting :( Alright I have attached a more sane design the "bi-petal" one, takes 5 hours to print though due to supports, the bottom part that's an almost 90 deg transition