Sony FDR-X3000 AKA-MCP1 Lens Cap

thingiverse

This is a snap-on lens cap designed for the Sony robust lens protector AKA-MCP1. Be cautious when removing it from the camera, as a tight fit could potentially pull the lens protector off and damage its mount. The lens protector's tabs hold it in place with relatively weak force, so if the fit is too tight due to printer calibration issues, you may want to file down the two holding tabs slightly. If you're looking for a lens cap that fits an underwater housing, consider mann1861's design, which I've created and found to be a good fit. However, note that the size of the lens on the underwater housing is different from the AKA-MCP1 model. Print Settings: Printer Brand: Prusa Printer Model: Prusa Mk2 Rafts: No Supports: No Resolution: 0.15mm Infill: 20% Notes: This print should work with any calibrated printer, as long as it's properly set up.