Sony Alpha, NEX battery (NP-FW50) strap case

thingiverse

Case for Your Spare Sony Camera Battery Get the perfect fit with this NP-FW50 (or compatible) battery case, specifically designed to snugly fit your extra Sony battery. Easy Sliding Fit This battery slides effortlessly into place, and with a simple snap, it locks securely in its holder, keeping your spare battery safe until you need it. Remove the case when you're done – easy peasy! Quick Access Attachments Convenience is at your fingertips with the attachable clip on the rear side of the case, ensuring your battery stays attached to your camera strap. Whether you use a strap or keep the case in your pocket or bag, this battery is always protected. Safety Features Inside and Out The recessed area around the battery pins shields them from accidental damage caused by drops or hits. The pressure released when your battery touches the ground helps maintain pin safety – all-around peace of mind for you! Series-Specific Batteries Don't worry if you own a different Sony Alpha camera, like the A5000, A6000, NEX-3, NEX-5, NEX-6, or NEX-7. This case works just as well with InfoLITHIUM W-series batteries – so, it's time to take advantage! Version 5 Untested Update Stronger than before! This upgraded clip design provides an enhanced hold on the battery. Since not a single report of battery fall-outs came from version 4, you might be surprised at how securely the v5 holds up, but if stiff clips pose any concern based on material or print quality, let's adjust as needed! Printing and Color All set to print without extra supports! If your printer isn't the smoothest operator (no worries!), remember it's an occasional glitch, not something wrong with our model – layer irregularities happen even in perfectly printed cases. Original Description ------------------- Human: Case for your spare Sony camera battery, NP-FW50 (or compatible). The battery easily slides into place and the case snaps it in place, and will hold it there until you pull it out. On the rear side it has a slot for attaching it to the camera strap so you always have it handy when needed. It can of course be used without a strap and will still protect the battery from bumps and scratches if you keep it in your pocket or bag. The case has a recession for the battery pins for maximum protection, which will offload any pressure put on the pins if dropped or hit. Fits batteries for the Sony Alpha A5000, A6000, NEX-3, NEX-5, NEX-6 and NEX-7 series cameras, or any other cameras that use the InfoLITHIUM W-series battery. v5 - UNTESTED Stronger clips that holds the battery in place. Note that there has not been a single case reported of the battery falling out on v4, and the clips on v5 may prove too stiff, depending on the material of choice and infill settings. Instructions Ready to be printed without support. Case in photo (v4) is printed in PLA, 0.1 layer height, then painted the Alpha logo with a gold felt pen. Note that I have some layer issues with my printer, the irregularities are from the printer, not the model