SonicPad Config (printer.cfg) for Sidewinder X1 Stock without Macro

thingiverse

After multiple search I could not find the .cfg for a Stock Sidewinder. So there it is! Will add Macro I need later here Guide: 1- Open the Sidewinder from underneath and disconnect the screen. The screen will no longer be used, you can close the printer 2- Start the Sonic Pad and select the "Other" printer all the way to the right of the selection menu. 3- Click on "Motherboard Firmware Compile" 4- In "MCU Frame", select ATMEGA and leave the settings below at their defaults. 5- Click on "Generate" at the top right corner and save the firmware on the provided USB key. 6- Retrieve the .hex file from the USB key and flash the SidewinderX1 with a slicer (or with PrusaSlicer). 7- Download the printer.cfg file from here 8- Turn OFF and reconnect the printer to the Sonic Pad on the port of your choice. 9- Turn ON the printer and click on "Get hardware serial port ID" 9- Modify the first section of the printer.cfg file to match the port indicated by the SonicPad ID given. "[mcu] #make sure this reflects your serial port you found when flashing klipper serial: /dev/serial/by-id/usb_serial_3" apparently: usb_serial_1 top left, usb_serial_2 bottom left, usb_serial_3 top back, usb_serial_4 bottom one and copy the file to the root of the USB key. 10- Connect the key to the Sonic Pad and click on "next step" The Sonic Pad will read the printer.cfg file and perform connection tests with the printer. +stand to fix the Sonic pad ;)