Solidoodle 3 e3d v6 bowden hot end mount

thingiverse

V2 update : \n X endstop surface extended so no bending out should be required.\n Switched from glue-in nuts to drop-in nuts, ensuring a secure fit.\n In Cura, set support material for bed only and let nut gaps bridge, worked perfectly.\ne3d printed with bowden mount for Solidoodle 3 (may also work on Solidoodle 2).\n Requirements: two M4 15-40mm bolts, two M4 hex nuts to superglue into the mount (changed to drop-in style in v2, no glue needed).\nThe two M4 bolts enable future accessory mounting.\n Two M3 bolts attach it to the stock carriage; I used existing ones that fit snugly.\n I had to carefully bend my X endstop out slightly to get it to trigger (fixed in v2).\n Printed at 40% infill, .3 layer height.\n Printed with support for the end stop wall. Rotate the clamp 180 degrees inside of the hot end interface is pointing upwards.