Solder Roll Stand

thingiverse

This is the correct stand on the picture. It matches perfectly with the following dimensions: Outer Diameter: 55mm Inner Diameter: 19mm Width: 30mm Print the base at a speed of 30mm/sec, with an infill percentage greater than 50% (depending on how many solid layers or perimeter walls you choose) and make sure your retraction settings are well-adjusted. The roller is printed with a low infill setting of 5% up to a height of 35.50 mm, after which you must switch to at least 50% infill (to ensure the smaller diameter end can be built upon). This can easily be achieved using two separate processes in Simplify3D. Supports are also necessary for the roller.