Solder fume (fumes) extractor for IKEA Tertial lamp (Lötrauch-Absaugung)

thingiverse

As I had some IKEA Tertial Lamps lying around here, I decided to give one of them a new life by upcycling it. This is a solder fumes extractor that will replace the lamp head of an IKEA Tertial Lamp. I'm using a BeQuiet! Silent Wings 3 High Speed Fan with dampening corners. You can also use a 120/230V fan and keep the original wire with the switch, but be careful - handling line voltage installations should only be done by professionals. Depending on the diameter of the fan mounting holes, you might need four M3 inserts to match the screws. With the BeQuiet! Silent Wing fan, the M3 just fits fine. Assembly: - Insert two nylock nuts into the Fan-Case. - Place the fan into the Fan-Case. - Insert four M3 nuts into the cutouts in the Fan-Case. - Screw the filter case onto the assembly using four M3x35mm screws. - Install a standard 130mm x 130mm x 10mm activated carbon filter. - Slide in the Filter-Fence or Filter-Fence_Thicker. - Unscrew the lamp head from the Tertial (and cut/replace the wiring). - Use two M3x16mm screws to fix the fumes extractor to the Tertial, and that's it. You need: Four cylinder head M3x35mm Four M3 Hex nut Two M3x16mm Two M3 Nylock nut One 120mm x 120mm Fan It is fully printable without supports. The small vertical thing in the cable opening is a built-in support and can be removed with a sharp knife. Model used for rendering: https://grabcad.com/library/lampada-ikea-tertial-1 Have fun!