Sojitek wireless charger holder for vent mount.

thingiverse

Cell phone cup mount for Sojitek Wireless charger-holding device specifically designed for cars, featuring a vent mount. Print Settings Printer Brand: MakerBot Printer: MakerBot Replicator (5th Generation) Rafts: Yes Supports: No Resolution: 0.1 mm Infill: 10% Notes: Worked perfectly on the first try, so I decided not to experiment with it any further. Important tip: Use the provided O-ring on the vent hook for a tighter joint and added cushioning. To make the installation process easier, adjust the hook distance to create space between the hook and collar, as shown in the picture. This results in a lower profile when attaching the hook to the notch inside. After experiencing this issue firsthand, I discovered that cup holders come in varying sizes, with different dimensions for front and back holders, even on the same vehicle, such as my 2014 Jeep Cherokee. The design program's inability to simplify the process of tapering a cylinder is puzzling. To overcome this challenge, I added a tapered ledge to the top collar of the mount, which works effectively. A helpful suggestion: Create an indentation in the groove to secure the holder and prevent it from popping out. However, be cautious when clicking the holder into place, as the sharp angle on the indents can make it difficult to remove the holder without the attached device. To resolve this issue, you can either reduce the sharp angle of the indents or use a thin, flexible piece of plastic, such as a handicap mirror sign. Simply push the plastic sheet along the side of the holder to dislodge it easily.