Softsoap Collar Soap Saver

prusaprinters

<p>I recently purchased a new Softsoap bottle because the old one was getting seriously gross--even after years of (lots of) cleaning. Lo and behold the corporate scoundrels at Colgate-Palmolive have modified the pump to dispense<strong>way too much soap</strong> (wasting it)! I'm not talking, "a little bit more than before" I'm talking, "holy crap that's a lot of soap that just went on to my hand!"</p> <p><strong>Fight back</strong> against the excesses of corporate greed with this simple plastic collar that costs about a tenth of a cent in your filament of choice! Just print it, snap it on, and the bottle will dispense about half as much soap as before (aka, the right amount).</p> <h3>Print instructions</h3><p>Resolution and infill don't matter. Just print it.</p> <p>Pro tip: You can scale it on the Z axis to make it taller if you want to save more soap! I found that the amount dispensed is just about right for my (admittedly large) hands but you should know that designing soap savers is a slippery slope! ;)</p>