Socket Retainer Kit / Socket Rail Organizer

thingiverse

To learn SketchUp better, I decided to make my own socket dongles that fit 1/4", 3/8", and 1/2" drive sockets labeled as 25, 375, and 50 respectively. Although the 3D printer is on backorder and they are untested, I calculated proper clearances and ensured STL files load in Cura 13.06.4, Repetier 0.90c, and run virtually well in Repetier. The estimated cost per rail is ~$1 USD with a fill of 75% ABS at $30/kg, while the dongles cost ~0.15 to 0.21 USD depending on size. The rails have nibs preventing dongles from sliding off and measure 180mm but can fit in a 150mm print bed when rotated 45 degrees. Additionally, there's a "one-sided" rail with nibs only on one end for fusing or gluing two rails together. If anyone prints these, please share pictures and feedback to iron out any issues before my printer arrives.