Soccer Blast Paraphernalia

prusaprinters

You need to print the following models in the following quantities:two-sided.stl (10, 5 in each color)keeper.stl (2, 1 in each color)clicker.stl (10)rod_1.stl (2)rod_2.stl (2)side (6)washer (10) I print these in PLA with a 0.3mm layer height. None of the models need to be printed with supports. I recommend printing 5 two-sided.stl models and 1 keeper.stl model in one color and the other set in another color.Print the strip.stl file with a layer height of 0.2mm or less. If your printer and slicer software support it, I recommend printing the strip in 2 colors. For example, print the top layer in white and the bottom layers in black. I also recommend setting your slicer to iron the top layer. It’s not required to fit the pieces together, but it looks much nicer.Insert a clicker onto each two-sided card holder. Each clicker should have the same alignment as the other clickers on its team. See the image below.You need 4 axially magnetized magnets of size 3/16" diameter by 1/4" thick. These can be acquired from K&J Magnets (links below) though other magnets of that size should work fine.https://www.kjmagnetics.com/proddetail.asp?prod=D34 (sufficient)https://www.kjmagnetics.com/proddetail.asp?prod=D34-N52 (slightly better)Insert magnets into the ends of all the rods such that the rod_1s are attracted to the rod_2s. Watch the video on the my YouTube channel to see the suggested assembly steps.