SoaPiBarZero

thingiverse

18th Feb - I've uploaded more combinations for you to choose from. 2nd Mar - A case version for the Scroll pHat board has been added. SoaPiBarZero - This is a soap bar shaped enclosure designed specifically for the Raspberry Pi Zero. It includes cutouts for gpio, processor heat sink, activity led, and access to the sd card. The gpio can be accessed from above or below depending on your selection, and it will fit either a male or female header. The heat sink opening accommodates a standard 14x14mm heat sink. I'll be uploading various versions of the top and bottom parts with or without upper and lower gpio, heat sink, and eyelet options so you can mix and match them as desired. Print Settings: Printer: Zortrax M200 Rafts: It doesn't matter. Supports: Yes Resolution: Tested at 0.09 - 0.14mm Infill: Light or medium Notes: Tested in Z-ABS, Z-ULTRAT, and Z-HIPS materials. Post-Printing: Assembly Instructions You'll need 4 x M2.5x8mm nylon screws and nuts for assembly. If the nylon screw is longer than required, you can trim it with a sharp blade after installation. Alternatively, you can use M2.5 metal hardware if preferred.