Soap dispenser “bubbles”

myminifactory

Would you like to support my work? :) Check out my full catalogue with exclusives, early access and commercial licences.   A beautiful soap dispenser intended for refilling. Upcycle a dispenser of a used soap bottle to create this piece. Avoid some plastic waste and have a unique soap dispenser in your bathroom! 3MF Multicolor files for bambulab AMS included! Fill Volume: 300ml Step-by-step Find an empty soap dispenser bottle and unscrew the pump. Alternatively, you can buy high end looking pump, too. Measure the diameter of the opening of your pump where the thread sits.   The threads of these dispensers are standardized. Most widely used are GPI/SPI Neck finishes. I included the two most common types that fit the majority of such pumps. Soap_dispenser_A: fits 28/400 28/410 28/415 threads with a pump opening width of approximately 28 mm (1,1 inch) that fits bottle mouths of 26 - 28 mm (1.02 – 1.10 inch) Soap_dispenser_B: fits 24/400 24/410 28/414 threads with a pump opening width of approximately 24 mm ( 0,95 inch) that fits bottle mouths of 23 - 24 mm (0.90 – 0.95 inch)   Choose your file and print it Check the length of the pump tube. If the original bottle was about 250 – 400 ml it should fit. If you use a pump intended for a originally bigger bottle (f.e. 500ml) it may be a bit too long. Cut off a piece of the tube with scissors to make it fit. Fill the print with a liquid soap refill bag and buy those from now on Have fun and enjoy avoiding some plastic waste along the way!   Size of the print: 84 x 76 x 139 mm Photos by Maison Lumiere