soap dish with scrubber tray

thingiverse

I have created this to hold soap and a scrubber in the kitchen. The soap is separated from the water by a honeycomb design, and there's a slot to drain excess water - the base slopes slightly for easy drainage. To keep it secure near the wash area and prevent slipping when wiping down with the scrubber, I attached it firmly in place. I designed this project using SolidWorks, then sliced it with Cura software. The print settings are as follows: * Printer: WanHao i3 Duplicator V2.1 * Resolution: 0.25mm * Infill: 20% Notes on the printing process: * I used Cura to slice the design. * Print speed: 40mm/s * Bottom layer speed: 10mm/s * Perimeter speed: 20mm/s * Travel speed: 90mm/s I designed this using SolidWorks.