Soap dish

thingiverse

A simple soap dish to replace a broken one turned out pretty well and has been in use for almost a week now. To achieve a smoother contact surface with the soap, I recommend using 0.15 mm or finer. Since I used multiple processes in Simplify3D, I opted for 0.3 mm up to the contact area, then switched to 0.15 mm. In retrospect, 0.1 mm would be perfect for this spot. For optimal results, I suggest printing with three perimeters and at least three top and bottom layers. In my case, I only added supports to the bottom, but the surface printed on top of it didn't turn out quite right. You might try bridging this area and see how it goes; after all, it's located inside.