Soap Dish

thingiverse

I was inspired by the "Taki Soap Dish" on Thingiverse, created by @cmar, but I wanted to add a recessed area to prevent soap from sliding out of the dish. Modeling began and eventually turned into this design. Adjust for larger soaps by stretching it in your slicer. You can print SoapDishA.stl for just the dish with a flat bottom. It prints well without support, brim, or raft using white PLA, but ABS should work fine with a hot enough bed temp due to the bottom surface area. If desired, print SoapDishB.stl, which is the retaining chin seen in the rendering. This keeps the tray from sliding back and gives runoff water a surface to drain along, leading it into the sink basin. Print this part with the flat side down and glue it under the soap dish for assembly.