Snowboard Vise

thingiverse

This is a 3D printable Snowboard Clamp. Store prices were outrageous, so I created my own design. The clamp is very straightforward to enable rapid printing and low resolution. You will need: -a large printbed 20x25 cm (a 200x195 mm version has been added) -a threaded bolt 10mm -a screw 17mm (optional, it works without it, but once the PLA thread wears out you can insert the screw-> see picture) The ball and plate are optional, I've included them to minimize damage to the table. I have also added a very thin layer of silicone at the top (to improve snowboard grip) and at the bottom (touching the table), so less tension is needed. Happy waxing and sharpening of the board!!!