Snow Saw Handle

myminifactory

Snow spots need handle replacement for the piece of heat shrink tubing that served as the original handle on the Life-Link snow saw. It should be printed in Ninjaflex or a similar elastic filament (the printed handle needs to stretch when installed). The handle is front-back symmetric so the same part can be used for either the left hand or right hand by rotating it. The handle's design includes a slightly wider slot that should be used as the top of the handle, considering its orientation during printing. This design was created specifically to fit the Life-Link snow saw, but there appears to be multiple versions in existence and I'm uncertain if this will work with all of them. Life-link is a registered trademark owned by a company that does not sponsor or endorse this specific design.