Snow Saw Handle

cults3d

Snow needs a new handle for the Life-Link snow saw, replacing the worn-out heat shrink tubing that served as the original grip. The replacement should be printed in Ninjaflex or an elastic filament like it, allowing it to stretch when installed. The handle is designed with front-back symmetry, making one part fit either hand by simply rotating it. However, the design lacks top-bottom symmetry, so the slightly wider slot must face upwards as the top of the handle, which will be printed upside down. This custom handle was created specifically for the Life-Link snow saw, but there may be variations in different versions, and I'm unsure if this design will fit all of them. LIFE-LINK is a registered trademark owned by a company that does not endorse or sponsor this specific design.