Snow Blower

thingiverse

This project is a snow blower for my TRX4 Defender.2023-12-03Finally, a test with some snow.First, the snow got stuck and melted onto the warm equipment.Then, letting the equipment adapt to the surrounding temperature, it worked well.Screenshot attached.2023-11-30Wiring done.Second Accu accomodated.Second motor controller added/plugged to existing receiver.Fixing of snow plow (respecively the adapter plate) to the front bumper finalized.Lifting and lowering ot the snow plow with help of the front winch tested and it works quite well.2023-10-14Updated, longer connection rods.Adapter plate added.Pics of bumper, for which the adapter plate fits, added.Updated MTO added, attached as *.pdf file.The level of the snow blow should be adjusted by help of my winch, attached to the bumper (no pic yet).So, for that I have changed the lower 2 M5 screws of the snow blow to a M5 thread rod for attaching the rope to that.Not yet tested any of these things, because the 3D printer is down at the moment :-(2023-10-06Full speed, no load test successfully (6V DC).Connection plate for TRX-4 Defender is under design.Not yet tested under real conditions.Because of the load of this device, I also had to design some suspension blockings for the standard size suspensions. MTO:1 x Brass Rod Dia 6mm x 300mm (or any other material)2 x Sealed Ballbearing Dia15 x Dia6 x 52 x Washer M6 x 14 x Screw M5 x 258 x Washer M54 x Nut M51 x original TRX4 Titan 21T 550 Drive (dia 36mm. length 57mm2 x GT2 belt pulley 20 tooth, inner Dia 5mm(one belt pulley has to be drilled out to 6mm Dia)1 x belt, length 200mmSuperglue