Snoopy vs Red Baron Bank (Compilation/remix)

prusaprinters

Snoopy vs Red Baron Bank This is a compilation (remix) of several different models posted here on Thingaverse. The original dog house (and lettering) came from here (very detailed model): https://www.thingiverse.com/thing:2792617 The Snoopy (Pilot Snoopy - Red Baron figure) came from here (also very detailed model): https://www.thingiverse.com/thing:2971170 Turning Snoopy's dog house into a bank was from my earlier remix, found here: https://www.thingiverse.com/thing:2798082 I rescaled Snoopy (down to 52mm) and then split him up into multiple parts so that he can be printed in various colors without painting (if you seen my other prints, you know how much I hate painting!). I also modified the ends of the scarf to make it an easier print. I reworked the roof from the original dog house so that the new Snoopy would sit on it. I ended removing Snoopy's tail because it didn't fit the model (as my wife says, "Poor Snoopy!"). I have pre-grouped all of the black pieces and copper pieces to make printing easier but the individual pieces are also here. Print Settings Printer Brand: Prusa Printer: i3 MK3 MMU 2 Rafts: No Resolution: .2mm Infill: 20% Filament: Hatchbox/Solutech/Amazonbasics PLA White/Real Black/Aqua Blue/Copper/Red Notes: I used 5 colors: White (Hatchbox) - Dog house, Snoopy's body and snout Black (Solutech Real Black) - Dog house lettering and door, Snoopy's nose and eye pieces Red (Amazonbasics) - Dog house roof and Snoopy's scarf Blue (Solutech Aqua Blue)- Snoopy's hat Copper (Hatchbox) - Googles, L&R Ear pieces Here were my print times (total - 27 hours, 35 minutes): Dog House base - 10 hours, 10 minutes Dog House plug - 28 minutes Dog House roof - 8 hours, 7 minutes All black pieces - 49 minutes All copper pieces - 1 hour, 5 minutes Snoopy's body - 3 hours, 3 minutes Snoopy's snout - 1 hour, 3 minutes Snoopy's hat - 2 hours, 10 minutes Snoopy's scarf - 40 minutes Supports were only used for: Dog House base (where plug goes) Snoopy's googles (or copper pieces if you print all of them at once) Snoopy-s body (I printed at an angle to get the best results) Category: Toys & Games