SNES Controller Charger

thingiverse

So I scoured the internet for a stand for the wireless SNES controller for the Nintendo switch that also charged it. I couldn't find one so here we are. It is intended for the USB-C cable that came with the controller, since the part was wrapped around the dimensions of the head of that cable. I recommend having your printer tuned in since it will be a tight fit since it needs to hole the cable in place so it doesn't push in or pull out, or especially bend the tip. There's a small notch on either side of where the cable goes that will latch it into place. One side bends, but it will still be tight. This is intentional. Be careful not to push to hard and break out the top of the hole like I did, but it will probably still hold pretty okay. 0.2mm layer heights should work fine, but I've had better success with 0.15mm layer heights. BE SURE YOU ARE HAPPY WITH IT BEFORE COMMITTING. THE CABLE DOES NOT COME OUT EASY. I printed with PETG to help with that flex, but PLA / ABS / Nylon / Whatever should work fine. Enjoy!