Snes Cartridge Height adjustment

thingiverse

Here's the minor height adjustment for SNES Cartridges that need to make contact at a slightly higher height due to region free mods or wear and tear. This offset is 2mm, where I noticed they made contact more often. I consider this companion piece for anti wobble, but it will likely work on PAL and Famicom versions as well. Check out the design here: http://www.thingiverse.com/thing:1094394 You can edit the height to what you need in the 123D file I added. This is a simple install - just slide it over the cartridge slot, which will be snug once on. You can press it in with a cartridge without opening your system. **Print Settings** * **Rafts**: Doesn't matter. * **Supports**: Doesn't matter. * **Resolution**: 15mm. * **Infill**: 20% hexagon. * **Notes**: This was printed on a Flash Forge Dreamer using PLA on a glass bed of 60c and an extruder at 200c. A lower resolution may be better if your printer can handle it, due to the thin design.