"Snappy" GPU Hanging Bracket for Wire Shelf/Rack Crypto Mining Rigs

thingiverse

Notice: This bracket is no longer updated. For the latest version with the best features, please visit our shop at https://www.GadCad3d.com/?coupon=GC3DGPU to get 10% off! No printer? No time? No problem! You can now order high-quality prints of our upgraded model on Etsy to save time and support our work! Free shipping on orders over $35, AND use this link for 10% off your order: https://www.etsy.com/shop/GadCad3D?coupon=GC3DGPU This version will remain free on Thingiverse for PERSONAL, NON-COMMERCIAL USE ONLY to support makers and miners alike. However, if this design has helped and you'd like to leave a tip I'd greatly appreciate it! PayPal: https://www.paypal.com/biz/fund?id=UB2QX593TZY66 BTC: bc1qz06rt4znskd8tkm4w2jtpfqtguwc5ls5cr6s09 ETH: 0x5bFFCfa38eba51ac2985292A13D4487bD61F718f -- This is a remix from USMCPelto's original upload. I loved the design but found the brackets sat a little too loosely on the wire shelf for my taste. This remix adds an extended, rounded lip to each of the retaining hooks to help your GPUs hang more securely. It "snaps" onto the metal wires nicely without being too difficult to install or remove. I adjusted it to fit an Amazon Basics shelf, but this should be compatible with most wire racks. Note: Standard PLA may warp/fail under warm conditions. For the safety of your equipment, I'd recommend using PETG or PLA+ at a minimum. Tip: If you have any GPUs with DVI outputs (e.g. 1660s or 1000 series) then you can safely clip some of the hexagonal mesh away to add clearance for the extruded port. Disclaimer: Use at your own risk. I personally haven't encountered any failures with these brackets, but the safety of your equipment is always in your own hands. Inspect all hardware before use.