Snapmaker J1 Top Riser with closeable ventilation slots

thingiverse

This is a riser for Snapmaker J1 printer, featuring closeable ventilation slots on each side. The J1 Top sheet may be locked using neodym 2x10mm Neodym Magnets in the corners (eg. https://www.amazon.de/gp/product/B06X977K8L ). You will need to print: <ul> <li>4x J1-Top-Riser_Corner.stl</li> <li>4x J1-Top-Riser_Corner_BottomExtension.stl</li> <li>6x J1-Top-Riser_FrontAndSideSlipProtector.stl</li> <li>4x J1-Top-Riser_BackSlipProtector.stl</li> <li>2x J1-Top-Riser_FrontConnector.stl</li> <li>2x J1-Top-Riser_FrontLeft.stl</li> <li>2x J1-Top-Riser_FrontRight.stl</li> <li>4x J1-Top-Riser_FrontSeal.stl</li> <li>1x J1-Top-Riser_SideLeft.stl</li> <li>1x J1-Top-Riser_SideRight.stl</li> <li>2x J1-Top-Riser_SideSeal.stl</li> </ul> Assembly instructions: <ol> <li>Print everything.</li> <li>Grind the 6 seals on the top and bottom to make them slide smoothely.</li> <li>Put the seals in the frond / side Parts. Move them a couple of times if thy do not slide smoothly.</li> <li>Give each slider a knob of your choice. I used M3 screws with 10mm electronic spacers.</li> <li>Super-glue the <i>Corner_BottomExtension</i> under each <i>Corner</i> using the given points</i>. This allows printing the parts without support.</li> <li>Super-glue the slip protectors using the given mount points:<br/> The 2 back parts are using the <i>BackSlipProtector</i> on the middle and outermost points.<br/> The 2 front and side pars are using the <i>FrontAndSideSlipProtector</i> using the outermost points.</li> <li>Put everything together. Use the <i>FrontConnector</i> to combine thee two left/right parts for the front and Back.</li> <li>Optional: put a 2x10mm neodym magnet in each corner part.</li> </ol> <b>Note:</b> The parts are designed for printing with a 0.4mm nozzle and a layer height of 0.2mm using PLA. In this setup the parts are fitting nicely together.