Snapmaker 2.0 Toolhead Holder - Wedge Lock V3

thingiverse

This is a set of parts that are meant to accessorize the Snapmaker 2.0 for easier use to store Tool heads. This is my V2 design which includes a notch on the side to accommodate the filament loading door release on the front of the 3D Printhead. In this design, I have the notch towards the end away from the mount to keep as much of the side wall intact to help with cantilever forces for shear strength. If you wanted, you could remix this design to mirror the "deep notch" to the left rear side to allow the 3D Printhead to sit in either orientation. I have my Controller Hub mounted 90 degrees from the original orientation to allow for me to have both of the "rear" of the uprights to mount items to. Look at the images for a better understanding of my situation that lead to this specific design. You will also note that the "wedge" on the rear of the holder is offset slightly to one side. I did this because the holder is slightly wider than then the upright and would push against the Controller Hub when mounted 90 degrees from standard as I have. Also, if you stow the 3D Printhead with the filament loading door towards the outside, then the door release will scratch at the Controller Hub (which is why I force you to stow with the filament door towards the inside of printer chassis).