Snapmaker 2.0 Pilar Top Filament Guide - Modified

thingiverse

Slightly modified filament guide to sit on top of a linear module and to help keep the filament where you want it. This is a remix from https://www.thingiverse.com/thing:4548376 I think the slit in the original guide was to allow setting the filament in. However, I prefer to have the guide be solid and thread the filament. I also like the shape of the base under the torus a little better. Using with a Snapmaker 2.0 A250 in an official enclosure. I have not complete decided yet whether the run the filament in front of or behind the extruder cable. Right now I am printing with it behind and it works fine but at the next filament change I may thread it in front instead. I mounted it with two extra M4 x 10 screws in holes opposite each other diagonally. I don't think you need to use four screws, unless you like the look better.